Mechanical strength of four allograft fixation techniques for ruptured cranial cruciate ligament repair in dogs.

Abstract

OBJECTIVE: To test ex vivo mechanical properties of 4 allograft fixation techniques for cranial cruciate ligament (CCL) replacement. SAMPLE: 30 stifle joints from canine cadavers. PROCEDURES: CCL-deficient stifle joints repaired by 1 of 4 techniques (n = 6/group) and CCL-intact stifle joints (control group; 6) were mechanically tested. Three repair techniques involved a patella-patella ligament segment (PPL) allograft: a tibial and femoral interference screw (PPL-2S), a femoral interference screw and the patella seated in a tapering bone tunnel in the tibia (PPL-1S), or addition of a suture and a bone anchor to the PPL-1S (PPL-SL). The fourth technique involved a deep digital flexor tendon (DDFT) allograft secured with transverse femoral fixation and stabilized with a tibial interference screw and 2 spiked washers on the tibia (DDFT-TF). The tibia was axially loaded at a joint angle of 135°. Loads to induce 3, 5, and 10 mm of femoral-tibia translation; stiffness; and load at ultimate failure with the corresponding displacement were calculated. Group means were compared with a multivariate ANOVA. RESULTS: Mean ± SD load for the intact (control) CCL was 520.0 ± 51.3 N and did not differ significantly from the load needed to induce 3 mm of femoral-tibial translation for fixation techniques PPL-SL (422.4 ± 46.3 N) and DDFT-TF (654.2 ± 117.7 N). Results for the DDFT-TF were similar to those of the intact CCL for all outcome measures. CONCLUSIONS AND CLINICAL RELEVANCE: The DDFT-TF yielded mechanical properties similar to those of intact CCLs and may be a viable technique to test in vivo.