Optimisation and improvement of in-line filtration performance in water treatment for a typical low turbidity source water.

Abstract

Forest catchments can produce high quality source water with a low turbidity. However, the combination of low turbidity, low organic carbon, and low temperature water conditions presents operating challenges in conventional water treatment processes. In this study, in-line filtration was tested using pilot-scale filter columns, and was found to be an appropriate option to treat a typical low turbidity water originating from the Rocky Mountains near Calgary, Alberta, Canada. When alum and cationic polymer were dosed simultaneously, in-line filtration produced high quality effluent with a turbidity and a particle count value of less than 0.1 NTU and 50 counts/mL, respectively. However, the alum and polymer doses and their ratios played important roles in the filtration efficiency. In general, short filter ripening times (i.e. <15 min) required an alum dose of at least 3&#x2005;mg/L and an alum to polymer dose ratio of less than 180:1. A longer filter stable period was associated with lower alum and polymer doses, as long as their doses were at least 2 and 0.024&#x2005;mg/L, respectively, and their dose ratio was maintained in the range of 30:1 to 130:1. The optimal alum and polymer doses were observed to be 3 and 0.072&#x2005;mg/L, respectively. Filter performance was enhanced when higher alum and polymer doses were used for ripening, and lower doses were applied during the stable filtration period. In addition, in-line filtration resulted in the reduction of microspheres by 3.6 logs under the tested water conditions. Hence, a similar removal efficiency is anticipated for.